How I remove my builder gel for a fill pt. 2 💅🏻🫧

The question I get asked most is how I remove my nails. 🫧💅🏻🤍

Step 1: Adjusting the settings for your drill. If you are holding the drill in your left hand it should be in R. If you are holding the nail drill in your right hand it should be in F.

You need to make sure the settings are right when you are working with a course bit or it will skip and could break your nail.

Step 2: Work in slow steady movements. I like start from left to right. Apply steady soft pressure when taking off bulk product. The angle of your drill is key. Looking at your nails from straight on and the side will help you take off product evenly. Make sure to take off the product at the end of your nail so you can trim it easier.

Going back and forth or pressing too hard with the nail drill could cause a heat spike and it could damage your nail. This is the only drill bit you can’t tough the natural nail because it would damage it.

Step 3: Use the sanding band to take off any extra gel on the side walls of the nail. Buff the natural nail. And smooth it out for easier application.

The sanding band can touch the natural nail because it’s a very soft grit. Apply soft pressure to ensure no heat spikes. When using it in the side walls of the nail go gently as well.

Step 4: Use the cuticle bit to go in Reverse motions on the right side of the nail and in Forward motions on the left side of the nail.

This will open up your cuticle area so the product will be as close to the beds of your nails as possible.

Now your nails are all prepped for a fill. Thanks I hope this helped follow for more nail tutorials!

#Lemon8Diary #lemon8partner #nailtutorials #naildrilltutorial #nailteaching #nailsfromhome #nailsathome #nailsnailsnails #NailArt #shareyourthoughts